Progress PAS3000E User Manual download pdf (Page 20)

TROUBLESHOOTING

Problem Possible cause Remedy

You cannot activate the appli-

ance or operate it.

The appliance is not connec-

ted to an electrical supply or it

is connected incorrectly.

Check if the appliance is cor-

rectly connected to the electrical

supply.

Activate the appliance again and

set the heat setting in less than

10 seconds.

You touched 2 or more sensor

fields at the same time.

Touch only one sensor field.

The STOP+GO function oper-

ates.

Refer to the chapter “Daily Use”.

There is water or fat stains on

the control panel.

Clean the control panel.

An acoustic signal sounds and

the appliance deactivates.

An acoustic signal sounds

when the appliance is deacti-

vated.

You put something on one or

more sensor fields.

Remove the object from the

sensor fields.

The appliance deactivates. You put something on the sen-

sor field

.

Remove the object from the

sensor field.

The residual heat indicator

does not come on.

The cooking zone is not hot

because it operated only for a

short time.

If the cooking zone operated

sufficiently long to be hot, speak

to the service centre.

You decreased the heat setting

from

.

Start from and only increase

the heat setting.

You cannot activate the outer

ring.

Activate the inner ring first.

The sensor fields become hot. The cookware is too large or

you put it too near to the con-

trols.

Put large cookware on the rear

cooking zones if necessary.

comes on.

The Automatic Switch Off op-

erates.

Deactivate the appliance and

activate it again.

comes on.

The Child Safety Device or the

Lock function operates.

Refer to the chapter “Daily Use”.

and a number come on.

There is an error in the appli-

ance.

Disconnect the appliance from

the electrical supply for some

time. Disconnect the fuse from

the electrical system of the

house. Connect it again. If

comes on again, speak to the

service centre.

If you tried the above solutions and cannot

repair the problem, speak to your dealer or

the customer service. Give the data from

the rating plate, three digit letter code for

the glass ceramic (it is in the corner of the

glass surface) and an error message that

comes on.

Make sure, you operated the appliance cor-

rectly. If not the servicing by a customer

service technician or dealer will not be free

of charge, also during the warranty period.

The instructions about the customer service

and conditions of guarantee are in the guar-

antee booklet.

20 progress

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Comments to this Manuals

No comments